Ensuring the safety of plant protection drones In addition to the use of machines that meet quality requirements and regular maintenance of the equipment, an important measure is to do routine inspections before the plant protection drones are in operation. In order to help the users to improve their safety awareness, we have invited professional technicians to give you a detailed introduction to the requirements of the routine inspection work of the plant protection drone.
The operator should develop good habits. Every time you start spraying the plant protection drone, you must carry out routine inspections. From top to bottom, from front to back, from outside to inside, the engine can be started after inspection. The specific matters are as follows:
1. The plant protection drone arm checks and ensures that the arm is not damaged, fully unfolded, and the screw is not loosened.
2. The propeller is inspected to ensure that the edge of the propeller is intact and intact, the propeller is installed securely, and the screws are not loose.
3. Check the boom to ensure that the boom is fully deployed and the screws are not loose.
4. Check the nozzle and ensure that the nozzle is facing down, no damage, no looseness, no dripping, no blockage.
5. Check the air pressure hose and ensure that the air pressure hose is firmly connected to each joint, no dripping, no blockage. Air in the hose can also cause the nozzle to clog. At this point, open the bleed valve on the nozzle to vent the air, and then close the bleed valve.
6. Check the landing gear and ensure that the landing gear is not damaged and the fastening screws are not loose.
7, the battery check and ensure that the battery is installed firmly, the battery voltage meets the operational requirements, the battery has been connected to the low voltage alarm.
8. Check the medicine box and make sure that the medicine box is not broken, no dripping, and the medicine box cover is tightened.
9, remote control, ground station to ensure that the remote control, ground station equipment has sufficient power to carry out operations.
10. Make sure the magnetic compass is calibrated.
11. Ensure that the plant protection drone GPS searches for more than 8 satellite signals to fly.
After each flight, you need to develop good habits, clean the whole machine, and check whether the screws of the Anhui plant protection drone into each main component are firm, whether the moving parts are too large, whether the push rod is firm, and whether the body has Obvious cracks, etc.
With Cummins Engine Generator,Cummins Diesel Generator,Cummins Diesel Generator Set,Cummins Diesel Generator Get
Shanghai Kosta Electric Co., Ltd. , https://www.ksdpower.com