A few days ago, Shandong Dongying incorporated the construction lighting design into the scope of construction drawing review, and the project that did not adopt LED environmental protection and energy-saving lamps was not approved. It is understood that this is another major measure taken by Dongying City to cope with the integration of the Yellow River Delta Efficient Ecological Economic Zone into the national development strategy to further promote the construction of environmentally-friendly cities. After that, the newly designed construction projects in the Dongying area must adopt LED lamps, and the unused construction engineering design and construction drawings will not be passed. The construction lighting system must be redesigned through the construction drawing review unit. This move will play an active role in promoting the city's promotion of environmentally friendly energy-saving products.
4.2mm Wire To Board Connectors
4.2mm Wire To Board Connectors are avialable in different terminations and sizes intended for use on a variety of applications. These connectors provide power and signal with different body styles, termination options, and centerlines. To find the wire to board set required, click on the appropriate sub section below.
4.2 mm pitch connectors wire to board connectors
Fully isolated terminals, positive locking housings, low-engagement forces and polarized housings, also offers blind mating, TPA and higher current options. Pitch 4.20mm
4.2 mm pitch connectors wire to board connectors Including:
male housing
Male housing of connector, UL94V-0 and UL94V-2, hanging and panel mount, single row and dual row, 2 to 24 circuits.
Female housing
Female housing of connector, with locking latch in order to avoid loosing, and with polarity in order to avoid dis-mating. One row and dual rows, from 2 circuits to 24 circuits.
Terminal
The conductor of connector, brass or phosphor bronze, tin plated over nickel, selective gold plated as customer's requirement.
Header
Header, right angle and vertical , with peg and without peg, DIP soldering, single row and dual row, 2 to 24 circuits.
4.2 mm connectors wire to board connectors General Specification:
Current rating: 6A AC, DC.(AWG#18)
Voltage Rating: 600V AC,DC
Withstanding Voltage: 1500V AC/minute.
Insulation resistance: 1000MΩ min
Contact resistance: Initial Value/ 10mΩ max
Temperature rise: -40'C ~ 105'C.
Circuit Board Connectors,4.2Mm Wire To Board Connectors,4.2Mm Pcb Wire To Board Connector,4.2Mm Pin Wire To Board Connector,.165" Wire To Board Connectors,4.2mm Power Connector
ShenZhen Antenk Electronics Co,Ltd , https://www.antenkelec.com