If the plant protection drone is unstable, it will seriously affect the effect of fighting drugs, which is also a big problem that plagues many farmers. This issue of the extension of the small series for everyone to organize the avoidance measures and detailed solutions.
Avoidance measures
1. When the blade is damaged and replaced, a pair of blades should be replaced at the same time, otherwise the blade balance will be affected, resulting in unstable flight attitude.
2. Each time the job site is replaced, a compass calibration is required, and then an empty flight test is performed to observe the star search situation and the aircraft state, and then start the load operation.
3. The tripod with compass pays attention to moisture and protects
4. When the plant protection drone is shipped from the factory, the motor has a certain angle. If the arm is replaced, the motor angle needs to be adjusted.
5. Avoid plant protection drones with sick operation when the flight attitude is unstable.
solution
1. Check that the blade is tight and the pad gasket is installed with or without errors.
2. Recalibrate the inertial measurement unit.
3. Disassemble to see if the inertia measurement unit pad is loose, clean the dust, replace the inertial measurement unit or compass
4. Calibrate the remote control
5. Brush the pan and turn counterclockwise for 3 turns
6. After replacing the arm, adjust the motor angle.
Why does the attitude sway when hovering in GPS mode?
1. GPS support rod shaking
2, magnetic compass interference is serious
3. GPS is too far from the center position (more than 20cm)
4, frequent gusts
The above is today's extension encyclopedia. If you have any knowledge you want to learn about plant protection and flying defense, please add Xiaobian as a friend and let me know~
Range Hood,Auto Cleaning Range Hood,Hood Range For Kitchen,Cooker Range Hood
Shandong Sangle Group Co.,Ltd. , https://www.sangle-group.com